11
Understanding that each cabinet, enclosure, rack and application is unique,
Wiremold has designed four solutions for mounting the 30 Amp Power
Distribution Units using the universal T-slot built into the unit. The mounting
kits listed below are available for purchase as accessories.
Custom options are available to meet your unique requirements. Available options include:
• Input voltage of 125V, 208V, or 250V • Variable number of receptacles
• Multiple circuits available • Variable length
• Dual Input System • Mounting Accessories
• Increased Amperage Available • 10KA AIC Breaker
• Plug Type: L5-30P, L14-20P, L6-20P, L14-30P, L21-20P • UL Listing available on select custom options
• Outlet types: Simplex or Duplex; NEMA 5-15R, • Custom colors available
5-20R, and 5-15IG; IEC Receptacles C13, C19
• Lower Profile Housing Available 2" W x 1 3/4" H [51mm x 45mm]
Custom Options
Mounting Accessories
Catalog No. 30A-MK1 – Z Bracket
Sturdy anodized aluminum bracket offsets
the unit for front access to the mounting.
May be used for a side or
end mount.
Catalog No. 30A-MK2 – L Bracket
Allows mounting at a right angle. May
be used for a side or end mount.
Catalog No. 30A-MK3 – Swivel Bracket
Allows unit to be mounted then rotated up
to 270° (dependent on mounting location)
providing easy access to unit’s face
without losing space.
Catalog No. 30A-MK4 – Drop-In Clip
Clip is mounted directly on the unit and
allows the strip to install with a ‘drop
and hold’ method that requires no
additional hardware.
For additional custom options,
contact your local Wiremold sales
representative for assistance.
NOTE: Accessory mounting kits are not UL Listed.
Standard Hardware Installation
Attach the Spring Clips to the cabinet frame
or cabinet wall making sure the top clip is no
more than 1 inch [25mm] from the top of the
unit. Insert the 1/4 - 20 Phillips screw through
the spring clip as shown, and then through
the cabinet frame or cabinet wall. On the
other side of the mounting surface, put the
1/4 lock washer over the exposed Phillips
screw and tighten into place with the 1/4 - 20
nut. Once the spring clips are secure, place
unit in one side of the clips and snap the
other side into position.
1/4-20
Phillips
Spring
Clip
1/4 Lock
Washer
1/4-20
Nut
Cat. No. BRK00329BULK
Comments to this Manuals