Any-port-to-any-port
serial communication—no
“master port” is needed.
Configure each port
independently, and set each
port independently, including
the DTE or DCE setting.
Converts between data
rates, data formats, and types
of flow control.
Up to two (base unit) or
four (expanded) simultaneous
connections are possible.
All connections can be
cleared simultaneously.
Can be reset or restored
to default settings remotely.
W
hat do you do if you have
one or more PCs, a few RS-
232 peripherals, and data that
needs to flow between
them, from
Point A to Point B,
or Point A to
Point C, or sometimes even from
Point D to Point E?
The Code Operated Matrix
Switch (COMS) might be just what
you need. It performs any-to-
any
switching between its five
ports in
response to ASCII-character-
based commands. If you have
more than five devices, you can
add the 4-Port Expansion Board
for a total of nine ports. Or you
can even cascade COMSes.
It doesn’t matter if your
devices aren’t absolutely
compatible. Each port on the
COMS can be independently
configured for data rate, data
format, flow control, and break
detection. You can also
independently set each port as
DTE or DCE, so you can use
straight-through-pinned
cables to
connect most devices.
By sending the proper
commands, any port can connect to
Switch up to nine serial devices—any device to any device—without extra conversion hardware or
software.
During the day, one PC can receive orders through your
mo
dem
while another directs an RS-232 industrial controller to
fill the
orders. At closing, the first PC can send reports to
the printer
while the second uses the modem to relay info to HQ.
Depending on the requirements of the job, each of your four PCs
can print to any of your five serial printers.
Any-to-any switching
without serial
compatibility problems.
This adaptable switch
converts flow-control
requirements, data
formats, and data rates.
Typical Applications
and disconnect from any other port,
or (as a third party) make or break a
connection between any two other
ports. There can be as many
simultaneous connections through
the COMS as the number of ports
will permit. On a base unit with
five ports, two simultaneous
connections are possible; on a
unit
with the Expansion Board
installed,
as many as four such connections
are possible.
(The COMS has a 31-
KB buffer
to keep data intact, even
with four devices sending at
once.)
In emergencies, or when John
Key Features
and Jane leave without releasing
their
peripherals, one command
can
break all existing connections.
If you should ever have
problems, another command
resets the COMS. You can set the
unit’s DIP switches to clear or
maintain existing connections
when the unit is reset.
Code Operated Matrix Switch
Overview
10906
1
Comments to this Manuals