Black Box MDS920C-10BT User Manual

User Manual Desktop: MDS932AE-10BT-R2 MDS932AE-FXO-R2 MDS932AE-FXS-R2 MDS933AE-10BT-R2 Rack Cards: MDS932C-1-R2 MDS932C-2-R2 / MDS933C-R2 G.SHDSL M

User Manual 2.2 Exterior design Rack Card models (MDS932C-1/2 or MDS933C-R2) Version: 1.9 Page. 10 of 29

User Manual Status(L) informs the user about the status of the local device. The following four statuses are possible «blinking red» inform

User Manual 3 RULES OF SWITCHING 3.1 The DESKTOP delivery set The delivery set includes: • the subscriber access device (a modem) • the power

User Manual 3.4 Communication parameters of the terminal configuration It is necessary to set the following parameters to monitor the modem: •

User Manual 4 THE COMMAND SYSTEM 4.1 Basic rules After the command is typed, press <enter>. The <Backspace> key is used to edit comma

User Manual 4.3 Performance management submenu Upon activation of the performance management submenu the following message will be displayed.

User Manual 4.3.2 Ethernet Status submenu Upon activation of the performance management submenu the following message will be displayed.

User Manual 4.3.3 HDLC Status submenu This menu contains statistical information about the HDLC packets that are sent between master and slave.

User Manual 4.4.1 DSL Setup In this menu you can setup the DSL link. When you have selected that menu, the following will appear:

User Manual 4.4.1.4 Fixed Connection Speed (only if Fixed is selected) • In the Fixed Connection Speed menu, you can specify your desired speed

User Manual © Copyright ©2006 by Black Box Network Services. The contents of this publication may not be reproduced in any part or as a whole, t

User Manual 4.4.2 Ethernet Setup submenu Configuration Management->EtherNet Setup 1.[Speed]:Auto

User Manual 4.4.3 Profile submenu Users can save and load up to 4 profiles for different tasks. The Profile 0 is the default profile during power

User Manual 5 TFTP UPLOAD 5.1 Unit preparation Its suggested to connect the PC Terminal to the monitor connector for the observation of the downl

User Manual 6 SNMP 6.1 Traps The unit supports the following traps: Trap Description Cold start Sent on unit startup Linkup Sent on DSL link

User Manual 7 TECHNICAL SPECIFICATIONS The main technical specifications of modems of the Black Box family are presented below in the table. Line

User Manual 8 STORAGE CONDITIONS The equipment of the Black Box family while being packed should withstand all means of transport at a temperatur

User Manual 9 CONNECTOR’S DESCRIPTION 9.1 DSL Connector Desktop units (MDS932/933AE-10BT-R2) Type: RJ-45, 8 pin Number Signal Assignment 1,2 NC

User Manual 9.3 Monitor Connector Type: Sub-D9, female Number Signal Assignment 1 NC - 2 TXD Transmit data 3 RXD Receive data 4 DTR Data

User Manual 9.5 Line1 and Line2 Connector (MDS932AE-FXO/FXS-R2) Type: RJ-11, 4 pin Number Signal Assignment 1 NC - 2 LA,a tip 3 LA,b ring 4 N

User Manual 10 DESCRIPTION OF INTERFACE CABLES 10.1 Ethernet cable Side А Color of wire Side B 1 white/green 1 2 green/white 2 3 white/oran

User Manual VERSION CONTROL...5 1 G

User Manual 7 TECHNICAL SPECIFICATIONS...24 8 STORAGE CONDITION

User Manual VERSION CONTROL Version Date Major changes to previous version 1.0 31.12.2001 Initial version of the manual corresponding to ver

User Manual EU Directive 2002/96/EC and EN50419 This equipment is marked with the above recycling symbol. It means that at the end of th

User Manual 1 GENERAL INFORMATION • High-speed symmetrical data transmission over one physical copper twisted pair with the 135 Ohm impedance acc

User Manual 2 DESCRIPTION OF THE DEVICE 2.1 Exterior design Desktop models The front panel of the device has 3 LEDs or 5 LEDs with FXO/FXS:

User Manual The back panel of the MDS932AE-10BT-R2 and MDS933AE-10BT-R2 modem has: • The grounding bolt of the modem (option); • The “