Black Box EME1DC16 Specifications download pdf (Page 14)

724-746-5500 | blackbox.com

Page 14

724-746-5500 | blackbox.com

ServSensor EXP DC16

3.3 Setting up a Sensor (Daisychained Configuration)

This section describes the basic setup of a sensor in a daisychained configuration. It focuses on the dry contact sensor; however,

this basic setup process applies to all compatible sensors. If you require information on specific functions of a particular sensor,

then download the manual for that sensor from our Web site or locate it on your product CD.

Connect the two modules together by following the instructions below:

1. Insert a straight-through CAT5 cable into the “E-out” port.

Figure 3-10. E-out port.

2. Insert the other end of the CAT5 cable into the “E-in” port.

Figure 3-11. E-in port.

NOTE: Make sure you also have a 7.5-volt power supply connected.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 24 25

No comments

Black Box EME1DC16 Specifications Page 14