Black Box ACU3009A Specifications download pdf (Page 42)

5. If the Local Unit’s LED shows that the link between the Units appears to be

working, make sure that the remote keyboard functions and that you’re

getting video at the remote site. (Be aware that in Dual-Access systems, remote

monitors, keyboards, and mice might take up to several seconds to be

properly initialized; see Section 7.3.3. Note also that the video quality might

be poor at this point if your interconnect cable is longer than 25 m [80 ft.]

and you haven’t set the Extender’s DIP switch to compensate for this; see

Section 5.1.)

6. Make sure the remote mouse functions. (If your PC normally boots up in

DOS, you will need to run Windows or some application that supports the

mouse.)

7. KVM/Serial/Audio systems only: Make sure that any serial device attached to

your Remote Unit is working. You might need to load a driver or run an

application in order for the CPU to be able to detect and handle the serial

data.

8. KVM/Serial/Audio systems only: Make sure that any audio devices attached to

your Remote Unit is working.

If everything works in your test setup, repeat the above steps for your actual

installation. If everything works in the actual installation, your ServSwitch™ Brand

CAT5 KVM Micro Extender system should be ready for continuous operation.

CHAPTER 6: Installation

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 61 62

No comments

Black Box ACU3009A Specifications Page 42