Black-box 5000 User Manual download pdf (Page 37)

CHAPTER 4: Base-Unit Installation

4.2 CommPak Cartridge Installation and

Removal

INSTALLING THE COMMPAK CARTRIDGE

The CommPak cartridge contains the operating

software for the Multiserver. When a cartridge is not

being used, it should be stored in an anti-static bag.

It is assumed that the CCM is installed. You cannot

install the CommPak cartridge unless the CCM is

installed.

Warning!

Any time that a CommPak is installed

or removed from the base unit, be sure

that the power cord is unplugged.

Failure to do so could result in damage

to the CommPak cartridge.

EMOVING THE COMMPAK CARTRIDGE

If you ever need to remove the CommPak cartridge

(such as for upgrading purposes), these are the

steps you should follow:

1. Unplug the power card from the ac power

socket.

2. Pull out the right side of the extractor handle.

3. Slide out the cartridge. The door will close

behind it.

4.3 Power Up the Unit

After the CommPak cartridge is installed in the

unit, plug the power cord into the back of the unit

and into the wall outlet. The Multiserver will power

up and automatically go into a self-test mode

(which lasts approximately 30 seconds).

4.4 LCD Display

MULTISERVER 5000

EXE

MULTISERVER 5000

EXE

Figure 4-2. Step one: Slide the CommPak

cartridge into the bottom beveled door.

The door will move out of the way.

(Do not use the top slot.)

Figure 4-3. Step two: Be sure to push in the

cartridge until it is flush against the

unit. To fully seat the CommPak

cartridge, you will need to exert

pressure. There must be no gap

between the cartridge and the unit.

MULTISERVER 5000

EXE

Figure 4-4. Pull out the extractor handle in order

to remove the CommPak cartridge.

Figure 4-5. Plug in the power cord after the

CommPak is installed.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 267 268

Comments to this Manuals

No comments

Black-box 5000 User Manual Page 37

Comments to this Manuals