Black-box 5000 User Manual download pdf (Page 43)

CHAPTER 5: Module Installation

5.2 Module-Location Switch Settings

Each expansion module has a module-location

switch group S1 that informs the software of its

location in the Multiserver unit (see Figure 5-2).

There are two exceptions: the CCM, which is always

in module location A, and the NMS module, which

is always located below the CCM. The physical

location of the switch is unique to each module.

Switch group S1 consists of four positions

numbered 1 through 4. Before setting S1, first

determine the location where the module is to be

installed. Then, set the switches to match the

intended module location. For example, if the

intended module location is C, set switch 2 on,

and the other three off. To set a switch on, use

a ballpoint pen or similar pointed tool and push

the switch down.

NOTE: Switch group S1 settings for module

locations B through E are different for each

module location (see Figure 5-2). Be sure

that each switch reflects the correct setting

for the intended module location. Also, take

care that only one switch is on (down) and

that the remaining three switches are off

(up).

SWITCH

GROUP

OPEN

FOR MODULE

LOCATION B

OPEN

FOR MODULE

LOCATION C

OPEN

FOR MODULE

LOCATION D

OPEN

FOR MODULE

LOCATION E

Figure 5-2. Switch S1 and module location settings.

Up position = open = off

Down position = closed = on

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 267 268

No comments

Black-box 5000 User Manual Page 43