Black-box 5000 User Manual download pdf (Page 49)

CHAPTER 5: Module Installation

5. Disconnect the fan connector from the CCM.

6. Disconnect the 34-pin NMS module ribbon cable,

if it is installed.

7. Unscrew the two screws in the back panel.

8. Gently remove the board by lifting it up.

5.6 Installation Procedures

The Multiserver unit contains electrosensitive

components that could suffer damage from static

discharge. Ground yourself by touching any

grounded equipment. You cannot ground yourself

by touching the Multiserver’s chassis. When the unit

is unplugged (off), it is not grounded.

External cables should not be connected until all of

the module installation is complete.

5.6.1 I

NSTALL THE SPACERS

Spacers must be inserted in the unit before

replacing the cover. Install a spacer in between each

of the modules. The spacers serve to maintain a

firm connection for the module connectors and to

secure the front of the modules.

5.6.2 I

NSTALL THE CCM

The CCM is always installed in module location A.

No other placement is permitted.

1. If the optional NMS Module has been purchased,

install it before installing the CCM. Refer to the

MS1 NMS Module User’s Manual for installation

guidelines.

2. Place the CCM module on the spacer in the front

of the unit.

3. Align the two holes on the module back with the

two holes on the back of the chassis. Using screws,

join the back panel to the chassis.

4. Connect the 12-pin power supply harness to the

CCM.

26-PIN RIBBON

CONNECTOR FROM LCD

12-PIN POWER

CONNECTOR

34-PIN RIBBON CONNECTOR

FROM NMS MODULE

FAN CONNECTOR

Figure 5-11. Installing the CCM.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 267 268

Comments to this Manuals

No comments

Black-box 5000 User Manual Page 49

Comments to this Manuals