Black-box 5000 User Manual download pdf (Page 230)

Multiserver 5000

228

LOCAL DIGITAL Diagnostic The RD signal is being internally looped to the

LOOP LINK # ci TD signal and transmitted onto the VF line.

LOCAL DTE LOOP Diagnostic The TD signal is being internally looped to the

LINK # ci RD signal.

LOCAL FOX Diagnostic The port is in a local fox loopback test.

ni LOCAL LINK RESTART ci Event Node ni on link ci has been restarted.

ni LOCAL SYSTEM RESET Alarm The local Multiserver unit has been reset.

LOCAL TEST, ECHO INPUT Diagnostic The port has been placed into a local echo loopback

test.

LOCAL TX/RX TEST Diagnostic The TX test pattern generator and RX error

PATTERN LINK # ci detector have both been activated.

LOCAL VF LOOP LINK Diagnostic The local receiver VF signal is being routed into the

modem, looped out through the local transmitter,

and amplified through a variable gain stage.

LOCAL 1004 HZ Diagnostic The local modem is transmitting a test tone

TONE LINK # ci of 1004 Hz over the telephone line.

LOCKED PARAMETER Event This parameter is locked out by the hardware

configuration.

LOGGING REPORT, Event Command Facility is not available because it is

TRY LATER being used to send reports.

MODULE NOT OPERATIONAL Info LAN module is installed but not operational.

<NO ANSWER> Dialog Indicates that no answer was received from the

async destination port. Causes include the

following:

• Remote port did not respond to connection

protocol.

• No response was received within the call

timeout period from the remote Multiserver,

although the ports are known by the local

Multiserver.

• Call inhibit is enabled (on).

• DTR = low = OOS.

ni NO ANSWER LINK ci Event The calling process has discontinued due to the

absence of an answer tone on a local dial line.

Screen Display Messages

Message Message Type Explanation

1 2 ... 225 226 227 228 229 230 231 232 233 234 235 ... 267 268

No comments

Black-box 5000 User Manual Page 230