Black-box 5000 User Manual download pdf (Page 237)

Appendix D: Messages

235

ARE YOU SURE? Info A reset is requested. If the answer is yes, press the

EXEcute key to proceed with the reset. If the

answer is no, press ANY OTHER KEY except the

EXEcute key to terminate without a reset.

ARE YOU SURE? Info You have attempted to reconfigure a node

EXE FORCES A RESET number and ID. This invokes a reset and this

message. Press EXE to accept the new config-

uration and invoke the reset. Press any other key to

abort.

BATTERY LOW ni Event or Alarm The CMOS battery at node ni is low, and a power

loss could result in a cold start of the system.

CHANNEL NOT Info The selected port is inoperative or the module

AVAILABLE location is empty.

CHANNEL TYPE NOT Info The port configuration for the selected port

APPLICABLE does not apply for the function requested.

Example: You request a channel reset for a port

configured as a link.

ni CMOS ERROR Event or Alarm The Multiserver software has detected a problem

writing to the Multiserver configuration area.

Contact your service representative.

CONFIGURATION ERROR Info An attempt was made to change the modem

NO ACTION TAKEN configuration, and the change did not take effect.

DIAL CONNECT MADE Event or Alarm The Automatic Dial Backup (ADB) option has

LINK ci completed the backup dial connection for link ci.

INTEGRAL DEVICE BUSY Info The system is very busy and you have attempted

modem diagnostics or configuration. Usually a

second attempt will succeed.

INTEGRAL DEVICE MODE Info You have attempted to execute a device

INHIBITS SELECTION function or option and the device is in a mode of

operation that temporarily inhibits the execution.

LCD Messages

Message Message Type Explanation

1 2 ... 232 233 234 235 236 237 238 239 240 241 242 ... 267 268

No comments

Black-box 5000 User Manual Page 237